Fantech PB In-line Fans

The Fantech In-line fan is designed to be installed between sections of round duct. This remote installation insures a low sound level at the grill. Indoors, the fan is usually installed in the attic with ductwork leading to a bathroom ceiling grill from one end of the fan, and ductwork leading to an outdoor roof or sidewall vent coming from the opposite end. Because the housing is made of Noryl plastic, the fan can also be mounted in outdoor (above ground) and wet locations. In addition, the fan is sealed to prevent moisture from entering the housing and to prevent leakage if the fan is to be used for radon mitigation. With the use of a Y-connector, a single in-line fan can ventilate two areas. Sound absorbing accessories are available, but are necessary only for very short duct runs.Sample Applications• Range hood exhaust• Dryer boosterThe Fantech PB 100 Kit The kit includes a 110 CFM fan, one mounting bracket, one ceiling grill with housing (in other words, everything that you need with the exception of the ductwork and on/off switch) uses 4″ duct. The Fantech PB 190 KitSame as above with a 190 CFM fan (uses 6″ duct )